Intermec SR61T1D

Chapter 4 — Enabling and Configuring Symbologies
SR60 Scanner Programmer’s Reference Manual 101
• If you need to set a second fixed length, continue with
Step 6.
• If you do not need to set a second fixed length, scan the
No Second Fixed Length bar code and skip to Step 8.
6 Scan the Set Second Fixed Length bar code.
7 Using the Digits bar codes on page 102, scan the digits to set
the second fixed label length you identified in Step 1.
8 Scan the END bar code.
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
Note: To set a label length less than ten, you must scan a zero
digit first and then the length digit (such as 04, 06, or 08).
Fixed Length Format
SET------------------------------------
Enable Fixed
Length Format ---------
Set First
Fixed Length ---------
Set Second
Fixed Length ---------