40
Version 1.1 (11/2011) en
Original language
Maintenance and cleaning
9006 Hybrid Control for RollerDrive
Maintenance and cleaning
Warnings concerning maintenance and cleaning
Maintenance
Checking the 9006 The 9006 must be checked at regular intervals to avoid malfunctions.
Monthly check the 9006 and its leads for visible damage.
Annually ensure that the screws of the 9006 are still tight and that the
cables are still laid properly and connected to the terminals.
Replacing the 9006 If a 9006 is damaged, it has to be replaced.
Install a new 9006 (see "Abandonment", page 45 and see "Assembly",
page 37).
Replacing fuse
Carefully use tweezers to remove and insert the fuse. Ensure you do not
damage the fuse holder, the circuit board or its devices.
Cleaning
Dust and dirt in combination with humidity may bridge the electric circuit.
Therefore, in a dirty environment, periodic cleaning will help to avoid short-
circuits which could damage the 9006.
Regularly blow off dust and dirt by using low compressed air.
Risk of injury due to improper handling or accidental
motor starts
Maintenance work and cleaning may only be executed
by qualified and authorized persons.
Only perform maintenance work after switching off the
power. Ensure that the 9006 cannot be turned
on accidentally.
Set up signs indicating maintenance work.
CAUTION
To Next Page
Loading...
Need help?
General
