49
Version 1.1 (11/2011) en
Original language
9006 Hybrid Control for RollerDrive
Appendix
Manufacturer's declaration
in terms of the EC-Machine Directive 98/37/EC and its amendment 98/79/EC,
Annex II B
The manufacturer:
Interroll Corporation
3000 Corporate Drive
Wilmington, NC 28405
USA
hereby declares with sole responsibility that the product range
• 9006 Hybrid Control for RollerDrive
is not a ready-to-use assembly in terms of the EC-Machine Directive and
therefore does not fully comply with the requirements of this directive. It
must not be put into service until the machinery into which it is to be
incorporated has been declared to conform with the provisions of the
Machine Directive.
Applied EC Directives:
Machine Directive 98/37/EC and its amendment 98/79/EC
Low Voltage Directive 2006/95/EC
EMC Directive 2004/108/EC
RoHS Directive 2002/95/EC
Applied harmonized norms:
EN ISO 12100 Part1 and Part2
Wilmington, NC, December 20
th
2010
Richard Keely
(Vice President of Manufacturing)
(This declaration can be obtained at www.interroll.com, if needed.)
To Next Page
Loading...
Need help?
General
