5
Version 1.1 (11/2011) en
Original language
9006 Hybrid Control for RollerDrive
Safety
Qualified persons
Qualified persons are persons who read and understand the manual and, taking
national regulations into account, can competently execute incidental work.
Only instructed and qualified persons may work with the 9006, taking the
following into account:
• the relevant manuals and diagrams,
• the warning and safety instructions in this manual,
• the system specific regulations and requirements,
• national or local regulations and requirements for safety and accident
prevention.
Risks
Persons Maintenance or repair work must only be executed by authorized and qualified
persons in accordance with the applicable regulations.
Before using the 9006, ensure that no unauthorized persons are near
the conveyor.
Electricity
Only perform installation and maintenance work after you have switched off
the power. Ensure that the power cannot be turned on accidentally.
Working environment
Do not use the 9006 in explosive atmospheres.
Remove equipment or material which is not required from the workspace.
Avoiding malfunctions in
operation
Regularly check the 9006 for visible damage.
In case of fumes, turn off the power at once and ensure that it cannot be
turned on accidentally.
Contact qualified personnel immediately to find the source the malfunction.
Maintenance
As the product is maintenance free, you only need to check regularly for
visible damage and that all leads and screws are still tightened.
Interfaces
By assembling the 9006 in a conveyor module, potential hazards may
occur. These are not described in this manual and have to be analyzed during the
design, installation, and startup of the conveyor module.
After assembling the 9006 in a conveyor module, check the whole
system for any new potential dangerous condition prior to turning on the
conveyor.
Important
The following list informs you about the various types of danger or damage that
may occur while working with the 9006.
To Next Page
Loading...
Need help?
General
