22
6.1.2.2. GSM band
Function - sets the frequency of locally-employed GSM system.
Data type - selection list
List - EU-900/1800 MHz
for areas employing 900/1800 MHz standard
US-850/1900 MHz
for areas employing 850/1900 MHz standard
Default
value
- EU-900/1800 MHz
Comments - Parameter active only in modules using quad-band Wavecom
WISMO Quick PLUS modem module. Setting US-850/1900 MHz
band in other modules does not have any effect
6.1.2.3. Access to configuration
Function - Can limit access to the device configuration. By this parameter
the user defines if changes in configuration are allowed only for
selected IP addresses or for all addresses
Data type - Selection list
Variation
range
- All
Access is granted for all IP addresses
List
Access is granted only for these numbers/addresses from
Authorized numbers|IP
list that have set the Configuration
option to Allowed.
Default
value
- All
Comment - Configuration access restrictions are limited only to the GPRS
connections. Misuse of the parameter can block the remote
access even for users who have access privilege
6.1.2.4. Configuration password
Function - Password protecting the module configuration. The user will be
asked for this password either during the local or the remote
access attempt. The password is an important way of protecting
against unauthorized changes of the module configuration. It
does not prevent reading either the configuration or the status
of the device
Data type - Text
Variation
range
- Letters and digits, 32 characters maximum
Default
value
- None
Comment - The only way to unblock the module is recalling the default
factory settings, and that’s why it is strictly recommended to
store passwords in a safe place
6.1.2.5. Use of GPRS
Function - Allows selection of the mode of operation of the module
Data type - Selection list
To Next Page
Loading...
Need help?
General