27
Comments - This parameter sets recipient's address for data frames testing
GPRS transmission channel sent after 4 minute elapses. Leaving
recipient address at 0.0.0.0 sends data frames to module's own
IP address. Any other valid address (within the APN) is accepted
as the recipient.
6.1.3.11. Number of login retries
Function - Number of unsuccessful attempts of logins to the network (or to
GPRS). Exceeding this number turns the module into standby mode
Data type - Number
Variation
range
- 0…255
Default
value
- 0
Comment - Setting this parameter to "0" means the login attempts can be
repeated infinitely
6.1.3.12. Idle time after login error
Function - Idle time (in minutes) which is required before starting the next
attempt of login to the network after an unsuccessful login event
Data type - Number
Variation
range
- 0…60
Default
value
- 5
Comment - Setting this parameter to "0" means login attempts will be
repeated without any delay
6.1.3.13. Data frame format
Function - Selects frame type used by modules in communication via GPRS
(and, indirectly, the operating mode of the modules)
Data type - Selection list
Variation
range
- Standard
Standard operating mode. Devices communicate between each
other and with other system elements using protocol and
transmission protection defined by the manufacturer
Open
Configuration and operating modes are the same as for
Standard frames. The only difference is lack of frame
protection and availability of header format in UDP frame. It
allows the user to create customized system of access to the
modules
Default
value
- Standard
Comment - For detailed information regarding "Open" format please contact
our company
To Next Page
Loading...
Need help?
General