34
Comment - Sets the flag used in rules processing
6.1.5.1.3.8. Alarm Lo
Function - The Lo alarm level for the signal on the analog input,
expressed in engineering units
Data type - Number
Variation
range
- 0…10000
Default
value
- 0
Comment - Sets the flag used in rules processing
6.1.5.1.3.9. Alarm LoLo
Function - The LoLo alarm level for the signal on the analog input,
expressed in engineering units
Data type - Number
Variation
range
- 0…10000
Default
value
- 0
Comment - Sets the flag used in rules processing
6.1.5.1.3.10. Alarm hysteresis
Function - The hysteresis value for the analog signal alarm levels
expressed in engineering units
Data type - Number
Variation
range
- 0…10000
Default
value
- 0
Comment - Setting the proper hysteresis value according to the variation
of the signal prevents too frequent alarm flag settings in
case of unstable signal source
6.1.5.2. Timers
The Timers group contains parameters used by two timers which influent the entire
module operation.
The Measure timer is responsible for periodic activation of the module in order to
make the measurements, to compute the increments, to check the alarm levels and
then to process the rules.
The Transmission timer was originally designated to initiate a transmission of the
data logger content, but its cycle can be also used in other transmission tasks.
6.1.5.2.1. Start
Function - A common start time used as the reference point for both the
measuring and the transmission timers
Data type - Time
Variation - 00:00…23:59
To Next Page
Loading...
Need help?
General