26
6.1.3.7. Spooler IP
Function - IP address of the computer which runs MTSpooler (i.e., the
program for automated update of the module configuration). After
login to the network the MT-703 module sends the information
about its readiness for a configuration update to the entered IP
address
Data type - IP number format
Variation
range
- 0.0.0.0…255.255.255.255
Default
value
- 0.0.0.0
Comment - If the MTSpooler is not used, this field should not be changed and
have 0.0.0.0 value. It prevents the repeated transmission attempts
when the successful sending of the activity information is not
acknowledged
6.1.3.8. GPRS transmission retries number
Function - The number of repeated attempts at sending information via GPRS
when the receipt confirmation is not received within the period
defined by the Transmission timeout
parameter
Data type - Number
Variation
range
- 0…255
Setting this parameter to "0" causes data to be sent without
waiting for receipt confirmation.
Default
value
- 0
Comment - Under normal conditions it is not recommended to set this
parameter value greater than 3. Such a setting is safe enough for
successful transmission and it does not block the processing of
consecutive rules. Note that the next data portion will be sent after
the successful end of current data transmission
6.1.3.9. Transmission timeout
Function - Time to wait for confirmation receipt (in seconds) after sending a
data frame.
Data type - Number
Variation
range
- 1.00…60.00
Default
value
- 9.00
Comment - This parameter together with GPRS transmission repetitions
influences the maximum time for sending a single data packet, that
equals (3 + 1) * 6 = 24s for default settings
6.1.3.10. GPRS testing IP
Function - sets IP address where data frames testing GPRS network state
are sent.
Data type - IP address field
Range - 0.0.0.0 - 255.255.255.255
Default
value
- 0.0.0.0
To Next Page
Loading...
Need help?
General