DA180 series basic AC servo drive Communication
-252-
32-bit fault code
(16-bit error code + 16-bit
additional information)
Setting fault–Incorrect software limits
Setting fault–Incorrect homing mode
Setting fault–PTP-control travel overflow
Regeneration discharge overload fault
AI overvoltage fault–AI 1
AI overvoltage fault–AI 2
EEPROM fault–Read/write error
EEPROM fault–Data check error
Hardware fault–FPGA fault
Hardware fault–Ground short-connection
fault
Hardware fault–External input fault
Hardware fault–Emergency stop fault
Hardware fault–RS485 communication
fault
Software fault–Motor control task re-entry
Software fault–Periodic task re-entry
Software fault–Illegal operation
I/O fault–Duplicate digital input
assignment
I/O fault–Duplicate AI assignment
I/O fault–Pulse input frequency too high
Main circuit undervoltage
Speed fault–CCW overspeed
Speed fault–Overspeed parameter set
incorrectly
Hybrid control deviation too large
To Next Page
Loading...
