Goodrive300-01 inverter for air compressor Function parameters
-71-
Detailed instruction of parameters
Source current is the positioning current of the
magnetic pole position. Source current 1 is valid
under the frequency point of current shifting.
Increasing the value can raise the starting torque.
Setting range: 0.0%~100.0% (rated current of the
motor)
Source current is directional current of the magnetic
pole position. Source current 2 is valid under the
frequency point of current shifting. There is no need
to modify the value generally.
Setting range: 0.0%~100.0% (rated current of the
motor)
Shift frequency of
source current
Valid frequency shifting point between source
current 1 and current 2.
Setting range: 0.00Hz~P00.03 (Max. output
frequency)
Superposition
frequency
(reserved)
Pulse
superposition
voltage
0.0~300.0% (rated voltage of the motor)
Maladjustment
detection time
Adjust the response of anti-maladjustment. Bigger
load inertia may increase the value, but the response
will be slower.
Setting range: 0.0~10.0s
High frequency
compensation
coefficient
When the motor speed is faster than the rated
speed, the parameter is valid, if vibration occurs to
the motor, please adjust the parameter.
Setting range: 0~100.0%
Braking current of
short-circuit
When P01.00=0 during the starting of the inverter,
set P13.14 to a non-zero value to enter the short
To Next Page
Loading...
