SV-DA200 series AC servo drive Appendix
-294-
PROFIBUS-DP fault–PWK parameters ID error
PROFIBUS-DP fault–PWK Parameters exceeds the
range
PROFIBUS-DP fault–PWK Parameters are read-only
PROFIBUS-DP fault–PZD Configuration parameter
does not exist
PROFIBUS-DP fault–PZD Configuration parameter
properties do not match
EtherCAT fault–initialization fault
EtherCAT fault–EEPROM fault
EtherCAT fault–DC Sync0 signal is abnormal
EtherCAT fault–Disconnection fault
EtherCAT fault–PDO data loss fault
Application fault–Encoder offset angle test overtime
Application fault–Encoder offset angle test failure
Application fault–Offside of homing
Application fault–Inertia identification failure
CANopen fault–CANopen disconnection
CANopen fault–SDO index does not exist
CANopen fault–SDO sub index does not exist
CANopen fault–SDO data length error
CANopen fault–SDO W data exceeds the scope
CANopen fault–Read-only cannot be modified
CANopen fault–PDO mapping length error
CANopen fault–PDO mapping data does not exist
CANopen fault–PDO is not allowed to be modified
during operating
CANopen fault–PDO mapping is not allowed
CANopen fault–Sync signal is too fast
CANopen fault–Receive fault
CANopen fault–Send failure
CANopen fault–Sync signal repeat
CANopen fault–The bus load rate is too high
CANopen fault–Parameter modification state error
To Next Page
Loading...
Need help?
General
