SV-DA200 series AC servo drive Safety precautions
-III-
related to electricity) to the enclosure or short connect the external cables, otherwise electric
shock or short circuit may occur.
Rewire the drive after 15 minutes when disconnecting the power supply, otherwise electric shock
may occur.
Do ground with proper techniques because the touch current may be 0.5mA, otherwise electric
shock may occur.
Do not touch the heat sink and external braking resistor during operation, otherwise burning may
occur for the hot sides.
Do install the overcurrent protector, leakage current protector and emergency device and ensure
the normal usage after wiring, otherwise electric shock, hurt and fire may occur.
The leakage current may exceed 3.5mA during the drive running. Do ground with proper
techniques and ensure the grounding resistor is less than 10Ω. The conductivity of PE earth
conductor is the same as the phase conductor (with the same cross area).
The components inside the drive contain heavy metal which should be disposed as industrial
waste.
To Next Page
Loading...
Need help?
General
