iPECS eMG800 - System Alarm Notification Control

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
248
2.81 System Alarm Notification Control
Description
Assigned stations receive the fault Alarm Signal, either a single tone burst repeated at 1-minute
intervals or a continuous tone. The Alarm Signal may be terminated at the phone by dialing the
Alarm Reset code or, if assigned, pressing the {ALARM RESET} button. To rearm the Alarm
function, the alarm condition must be cleared and the Alarm signal terminated.
When enabled, the Emergency call or fault event causes an alarm ring at the Station. The
Station can terminate the fault Alarm notification.
Station can have ‘Alarm Ring Coverage Button’ on flexible buttons for all or a specific type of
alarm. Multiple Stations who have a specific ‘alarm coverage button’ is notified for the specific
alarm ring. When the following desired ‘alarm type code’ is enabled, the station can view the
alarm information and terminate the fault alarm notification.
A station can have multiple buttons of ‘alarm coverage’ according to alarm types. Alarm type code
'0 (all) is notified for all type of alarm ring. But an alarm coverage button for a specific alarm type
goes first than 0(all) if there is.
Code No.
Alarm Type code
Alarm notification
Code No.
Alarm notification
0
All alarm
12
WTIM/WTIB Chain fail
1
Emergency call
13
ISMDR full
2
DCOB Fault
14
CABINET alarm (for UCP)
3
BATH
15
BAR full
4
DOOR-Bell
16
IPCR fault
5
Alarm-Bell
17
IPWATCH fail
6
Station Overflow
18
Temp License Expire
7
CO Overflow
19
License Expire
8
Alarm-Bell
20
License Overflow
9
Station Overflow
21
TNET License Expire
10
VM FULL
22
TAPI fail
11
WTIM/WITB Base fail
Operation
System
iPECS IP & LDP Phones
At detection of fault or Emergency Call, the Alarm signal is sent to assigned stations.
[TRANS/PGM] + {FLEX} + “*565” + [HOLD/SAVE]
To assign a Flex button as an {ALARM RESET} button to terminate the Alarm Signal
1. Dial the Flex Numbering Plan code “*565”, confirmation tone is received and the Alarm
Signal is terminated. If the alarm condition is cleared, the system will automatically rearm
To terminate an Alarm Signal, while idle by using {ALARM RESET}