iPECS eMG800 - SLT (Single Line Telephone); Broker Call

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
432
7. SLT (SINGLE LINE TELEPHONE)
7.1 Broker Call
Description
Broker Call allows a SLT user to engage in two (2) calls, alternating between the two parties, so
that the conversation with each party is private.
There are two types of Broker Call,
Transfer Broker call – the second call is originated by the SLT
Camped On Broker Call – the second call camped on the SLT.
Operation
SLT
1. Make or receive an intercom or external call.
To activate a Transfer Broker Call
2. Momentarily press the hook-switch, intercom dial tone received and active call is placed in
Exclusive hold state.
3. Place second call.
4. To alternate between calls momentarily press the hook-switch.
1. Make or receive an intercom or external call.
To activate a Camp-On Broker Call
2. Receive a Call Waiting/Camp-On tone.
3. Momentarily press the hook-Switch, intercom dial tone received and the active call is placed
on Exclusive Hold.
4. Dial the Camp-On Answer code “*621”, Camped on call is connected.
1. Momentarily press the hook-switch.
To alternate between the calls
2. Dial the Camp-On Answer code “*621”.
Conditions
1. After a hook-switch flash, if the call results in an error, busy, no answer or an abnormal
state, the SLT user may momentarily press hook-switch to retrieve the held call.
2. During a Transfer Broker Call, if the SLT user goes on-hook, the Broker Call parties
are connected completing a Call Transfer.
3. During a Transfer Broker Call, if the active caller disconnects from the SLT user, the
held party, if another station, is connected to the SLT. If the held party is an outside call,