iPECS eMG800 - Call Park

iPECS eMG80 & eMG800 & UCP
Feature Description and Operation Manual Issue 1.6
62
2.17 Call Park
Description
You may place an active Internal & External call in a special holding location called a Park Orbit
for easy access from any station in the system. There are 19 (eMG80) & 200 (eMG800/UCP)
Park Orbits allowing multiple calls to be parked simultaneously.
Operation
iPECS IP & LDP Phones
1. Press the [TRANS/PGM] button.
To park an active Internal & External call
2. Dial the Park Orbit number (eMG80: #601~#619 / eMG800 (UCP) #601~#800).
3. Return to idle.
1. Lift the handset or press the [SPEAKER] button.
To retrieve a parked call
2. Dial the Park Orbit number (eMG80: #601~#619 / eMG800 (UCP) #601~#800).
SLT
1. Momentarily press the hook-switch.
To park an active Internal & External call
2. Dial the Park Orbit number (eMG80: #601~#619 / eMG800 (UCP)#601~#800).
3. Return to idle.
1. Lift the handset.
To retrieve a parked call
2. Dial the Park Orbit number (eMG80: #601~#619 / eMG800 (UCP) #601~#800).
Conditions
1. If the selected Park Orbit returns a busy signal, the user may simply dial another Park
Orbit without the need to disconnect.
2. A Parked call will recall to the station that parked the call should the Call Park Timer
expire. The normal Hold Recall process is then initiated.
3. A Parked call will indicate busy at all appearances.
Programming
Keyset Admin.
SYSTEM
Call Park Recall Timer (PGM 180-Button 2)
STATION DATA
Web Admin.
Flexible buttons  Programming (Numbering plan)  Park
Orbit number