iPECS LIP-8008D - 6. REMOTE SYSTEM ACCESS; 6.1 DIRECT INWARD SYSTEM ACCESS (DISA); 6.2 MOBILE PHONE EXTENSION

LIP-8008D User Guide
22
3.3.4 Using and Entering Station Speed Dial Numbers
Each station in the iPECS-100 System is allocated
memory for 20 Station Speed Dial numbers (bins 00-
19) each up to 48 digits. The iPECS-300 & 600 & 1200
each support 100 Station Speed Dial numbers (bins
000-099). The iPECS-MG 100 & 300 each support 50
Station Speed Dial numbers (bins 000-049). These
numbers are entered at the user’s station and may
include several ‘special’ instructions. Special
instructions and the corresponding button are:
PAUSE will momentarily stop dialing.
FLASH as 1
st
digit—Activate dial tone detect.
FLASH not as 1
st
digit—The system will generate a
flash on the CO line.
CALL BACK as 1
st
digit—Send digits as ISDN
Keypad Facility message.
‘*’ as 1
st
digit—Display Security, the stored
number will not be displayed when used.
‘*’ not as 1
st
digit—Dial Pulse to Tone Switchover,
the system will switch from pulse to tone dialing.
When entering a Speed Dial, a 16 character name may
be associated with the number for Dial by Name.
To place a call using Station Speed Dial:
 Lift the handset,
 Press SPEED,
 Dial the desired Station Speed Dial bin number (00-19 or 000-
099 or 000-049).
To enter a Station Speed Dial number with CO Line and Name:
 Press TRANS/PGM,
 Press SPEED,
 Dial the desired Station Speed Dial bin number,
 Select/dial the CO/IP line/group,
 Dial the desired number to be stored,
 Press HOLD/SAVE,
 Enter the associated name, if desired,
 Press HOLD/SAVE.