iPECS LIP-8008D - Wake-Up Alarm; Alarm;Door Bell

LIP-8008D User Guide
34
7.4 Wake-Up Alarm
iPECS supports an Alarm Clock for each station. You
can set the alarm clock to repeat daily or as a one-time
alarm.
When responding to the alarm by lifting the handset,
BGM will be provided.
7.5 Alarm/Door Bell
The system can monitor external Alarm or Door Bell
contacts:
Alarm Monitor—should the external contact activate, a
unique Alarm Ring signal and LCD display may be
received. To restart the monitor circuit, the external
contacts must be deactivated and the Alarm Ring signal
terminated.
Door Bell—a unique Door Bell Ring (single tone burst)
may be received each time the external contact is
activated. A system contact also can be assigned to act
as a Door Open contact.
NOTE—Contacts 3 & 4 are only available in the
iPECS -300 & 600. Contacts 1 is available in the
iPECS -MG.
To set the Wake Up Alarm clock:
 Press TRANS/PGM,
 Dial 41(iPECS-LIK)/13(iPECS-MG) (Alarm Clock code).
 Dial hh/mm for time alarm should alert,
 Press # to have the alarm repeat daily,
 Press HOLD/SAVE.
To erase Wake-Up:
 Press TRANS/PGM,
 Dial 42(iPECS-LIK)/14(iPECS-MG) (Alarm Clock delete code)
 Press HOLD/SAVE.
To terminate the Alarm signal:
 Dial 565 (Alarm Stop code).
To activate the Door Open contacts:
 Lift the handset,
 Dial #* (Door Open code) and contact number 1 to 4.