| Appendix
144
YLS-K
12 Appendix
12.1 Status messages, warnings and alarms
The laser welding tool software shows three types of messages:
• Status messages
• Warnings
• Alarms
The type and number of the messages can vary depending on the con-
figuration of the product.
Status messages provide information about the current status of the sys-
tem.
A Warning indicates the preliminary stage of an alarm. A closer look at
the status or maintenance work is necessary.
An Alarm requires the elimination of the cause of the fault, adjustment
work or repair / replacement of a component.
The messages that may arise during operation are describe below. The
descriptions of the warnings and alarms also contain instructions on
troubleshooting.
To put the product back into operation after eliminating the problem,
the alarms must be reset. For some messages, this takes place automati-
cally; for all others, you must click the Reset
button in the LaserNet
Control tab.
WARNING
Danger of severe injuries
When performing maintenance and repair work on
the product, there is a danger of various injuries if
not all safety precautions are taken.
ð Only allow maintenance or repair work to be
performed by trained personnel or the compe-
tent IPG service department.
To Next Page
Loading...
