145YLS-K
WARNING
Danger from laser radiation
Laser radiation can damage the eyes and skin. The
system owner is responsible for compliance with the
laser safety regulations.
After the repair work is completed, the laser safety
must be fully restored.
ð Wear suitable laser safety glasses
(900 … 1200 nm) while present in the danger
area.
ð Additionally secure the danger zone, if neces-
sary.
ð Check the correct connection of all safety-re-
lated components.
Contacting IPG service
In the event of faults that cannot be rectified using
the following instructions, please contact the compe-
tent IPG service department and follow the proce-
dure described in Manufacturer’s service [}129].
12.1.1 Messages of the Status tab
Message
Laser power supply ON
Type
Status
Description
This status message is active when the laser power supply is switched
on.
The laser power supply is responsible for the supply voltage to the laser
modules.
This status is also referred to as Laser ON (Power supply ON = Laser ON).
Message
Internal control disabled
Type
Status
Description
This status message appears when the laser is operated in ROBOT mode
and the signal Internal control enabled is disabled.
| Appendix
To Next Page
Loading...
