IPSO IPD30STG User Manual (English)

Questions and Answers:

S
Steven IngramAug 16, 2025
How to troubleshoot IPSO IPD30STG Dryer motor that will not start?
- N
  Natalie OdomAug 16, 2025
  If your IPSO Dryer's motor won't start, begin by checking the fuses and circuit breakers. Ensure the main control switch is turned 'on'. For gas dryers, inspect the bonnet thermostat. Also, verify the power source, ensuring the voltage, phase, and frequency match the specifications on the electrical rating plate. Check the timer setting or coin meter operation. Inspect wire connections in the electrical box at the dryer's rear and make sure the loading door is fully closed. If these steps don't resolve the issue, the door switch might need adjustment or replacement. Similarly, the basket motor contactor could be defective and need replacement. Finally, for gas bonnets, check if the safety thermostat has tripped or is defective, and reset or replace it as needed.
M
Michael WhitneyAug 22, 2025
Why is the motor tripping on thermal in my IPSO IPD30STG?
- J
  Jessica IngramAug 22, 2025
  If your IPSO Dryer motor is tripping on thermal, check the voltage at the motor terminals, ensuring it's within +10% of the voltage on the motor rating plate. If not, consult your local power company. Also, consult with them to ensure your wiring is adequately sized for the load. Check all electrical connections and tighten any loose connections. Ensure adequate air by checking the installation sheet for recommended make-up air openings. Finally, clean any lint accumulation on and around the motors.
J
Julia HamiltonAug 25, 2025
How to fix a noisy or vibrating IPSO Dryer?
- J
  Jamie CarterAug 26, 2025
  If your IPSO Dryer is excessively noisy or vibrating, first check if it is properly leveled according to the manual. Accidental damage to the fan blade can change the dynamic balance, so damaged fans should be replaced. Adjust basket clearance if the basket is rubbing. Tighten set screws on V-belt sheaves and ensure they are properly aligned. Adjust belt tension. Also, check for any foreign objects, such as screws or nails, caught in the basket perforations and remove them immediately.
T
Tyler CoxAug 28, 2025
What causes main burners to burn improperly in an IPSO Dryer?
- T
  Timothy SmithAug 28, 2025
  If the main burners in your IPSO Dryer are burning improperly, ensure the orifice is spaced 1/4' (7 mm) from the burner opening. Blow out any dirt in the burner. Adjust the gas pressure per the rating plate if it is too high. If the orifice is too large, send it to the factory for correct orifices. Finally, clean any restricted or blocked exhaust.
R
rpageAug 31, 2025
What to do if the motor runs but the basket won't revolve in my IPSO Dryer?
- S
  Sara McmahonAug 31, 2025
  If your IPSO Dryer motor runs but the basket won't revolve, the V-belt may be broken or loose, requiring replacement or adjustment of belt tension. Alternatively, the motor pulley might be loose; tighten the set screw. If the basket is overloaded, remove some of the load.
W
washingtonshaneSep 3, 2025
Why is my IPSO IPD30STG Dryer too hot?
- M
  Mr. Jeffery Davis DDSSep 3, 2025
  If your IPSO Dryer is running too hot, replace the main burner orifices and check with the factory for the correct size. Ensure adequate make-up air, which must be 4 to 6 times the exhaust area of the dryer. Remove any accumulated lint. Make sure exhaust duct dampers are fully open or replace them if not. Adjust gas pressure per the rating plate if it is too high. Check the service section for recommended exhaust system sizes and remove obstructions or lint build-up from duct work. Never use a smaller size exhaust duct; always use a larger size. Replace the thermostat if it is defective.
D
Dominique NortonSep 5, 2025
What causes an IPSO IPD30STG Dryer to not stop at end of time period?
- G
  Gary GraySep 5, 2025
  If your IPSO Dryer does not stop at the end of the time period, the timer is likely defective and needs to be replaced.
K
Kelly CochranSep 9, 2025
Why does the main burner cycle on and off in my IPSO IPD30STG?
- U
  uburgessSep 9, 2025
  If the main burner cycles on and off in your IPSO Dryer, the direct spark ignition is defective and needs to be replaced.
E
Erica AndersonSep 12, 2025
What causes low or high gas flame in IPSO IPD30STG Dryer?
- O
  oortizSep 12, 2025
  If your IPSO Dryer has a low or high gas flame, replace the main burner orifices and check with the factory for the correct size.

IPSO IPD30STG Specifications

General

Brand	IPSO
Model	IPD30STG
Category	Dryer
Language	English

Summary

IMPORTANT NOTICES—PLEASE READ

FOR YOUR SAFETY

Safety information regarding flammable vapors and liquids near the appliance.

IPSO DRYER WARRANTY

IDENTIFICATIONNAMEPLATE

Location and content of the dryer's identification plate.

SYMBOLS

Unpacking and General Installation

Outline Dimensions

General Specifications

General Information

DRYER COOL-DOWN

Timed cycle that rotates fan and basket without heat to reach safe cool temperature.

Main Drive Motors

Details on the main drive motors, including specifications like HP, kW, Amps, and RPM.

Grounding Instructions

ELECTRICAL CONNECTIONS

Requirements for grounding the dryer using a separate wire and complying with electrical codes.

ELECTRICAL CONTROLS SERVICING

Cautionary notes for labeling wires before disconnection during servicing.

Gas Piping Installation

Gas Pressure

Specifies gas pressure requirements for natural and LP gas.

Gas Supply

Details the gas supply connections required for the dryer.

Gas Piping Installation (Illustration)

Pressure Testing Precautions

Disconnecting the dryer during gas piping system pressure testing.

Gas Service Installation Instructions

GAS PRESSURE REGULATOR FOR LIQUIFIED PETROLEUM GASES

Requirements for gas pressure regulators for LP gas installations.

Multiple Vented Installation

Single dryer

Recommendation for individual short straight exhaust duct for each stack dryer.

Multiple dryers

Recommendation for individual short straight exhaust ducts in multiple installations.

Testing

Information on testing ducting system pressure with a manometer.

Multiple vents

Diagram and details for typical multiple vented installation.

Dryer Installation With Separate Exhaust (Preferred)

Exhaust and Venting

DRYER AIR FLOW INSTALLATION

Importance of air flow for dryer operation and proper ducting.

EXHAUST DUCT

Guidelines for best drying practices regarding exhaust duct size, length, and bends.

MAKE-UP AIR

Requirements for make-up air openings to the out-of-doors for dryer operation.

OTHER RECOMMENDATIONS

Advice to consult local building code requirements for compliance.

TROUBLESHOOTING

Indicators of exhaust duct or make-up air problems like hot surfaces or slow drying.

Rules for Safe Operation of Dryer

Service Safety Precautions

Safety instruction to shut off power before servicing the dryer.

Flammable Liquid Precautions

Warning against using flammable liquids and fabrics treated with them.

ENERGY-SAVING TIPS

Tips for reducing energy consumption and improving drying efficiency.

Operating Instructions—Coin Meter Models

ELECTRO-MECHANICAL COIN METER

Instructions for using an electro-mechanical coin meter.

COMPUTERIZED COIN METER

Instructions for using a computerized coin meter with digital display.

Temperature and Fabric Selection

Guide to selecting fabric temperature settings (High, Medium, Low).

Starting the Dryer Cycle

Instruction to press the start button to begin drying and cooling cycles.

Post-Start Operation

Description of the dryer's operation after the start button is pressed.

Service Savers

DRYER WON'T START

Troubleshooting steps for a dryer that fails to start.

DRYER WON'T HEAT

Troubleshooting steps for a dryer that does not produce heat.

CLOTHES ARE NOT SATISFACTORILY DRY

Troubleshooting steps for clothes not drying properly.

GAS DRYER IGNITION

Instructions for troubleshooting gas dryer ignition issues.

Service Call Information

Importance of providing model and serial numbers when calling for service.

TROUBLESHOOTING

Troubleshooting Chart

Motor Will Not Start

Causes and remedies for the motor failing to start.

Motor Tripping on Thermal

Causes and remedies for the motor tripping due to thermal overload.

Dryer Does Not Stop at End of Time Period

Cause and remedy for the dryer not stopping after the timer expires.

Motor Runs But Basket Will Not Revolve

Causes and remedies when the motor runs but the basket does not turn.

Troubleshooting Chart

Dryer Noisy or Vibrating

Causes and remedies for dryer noise or vibration.

Dryer Runs, But No Heat

Causes and remedies for the dryer running without producing heat.

Troubleshooting Chart

Dryer Runs, But No Heat (Continued)

Further causes and remedies for the dryer running without heat.

Main Burners Burning Improperly

Causes and remedies for improper main burner operation.

Main Burner Cycles On and Off

Causes and remedies for the main burner cycling on and off.

Low or High Gas Flame

Causes and remedies for low or high gas flame issues.

Troubleshooting Chart

Dryer Too Hot

Causes and remedies for the dryer operating at excessive temperatures.

DIRECT SPARK IGNITION OPERATION

Dual Ignition System Note

Note on dual ignition systems and their independent operation.

DIRECTSPARK IGNITION OPERATION FLOW CHART

FRONT PANEL ASSEMBLY

DOOR ASSEMBLY

CONTROL PANEL

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the control panel.

LINT DRAWER ASS'Y

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the lint drawer.

THERMOSTAT ASS'Y

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the thermostat.

DMP CONTROL-COIN

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the DMP coin control.

DX3 COIN CONTROL PANEL ASSEMBLY

DMP CONTROL -OPL

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the DMP OPL control.

DX3 CONTROL PANEL ASSEMBLY

BASKET & SPIDER ASSEMBLY

REAR

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the rear of the dryer.

POWER TAP

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the power tap.

BASKET SUPPORT

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the basket support.

MOTOR ASS'Y

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the motor.

AIR SWITCH ASS'Y

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the air switch.

IDLER ASS'Y

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the idler.

REAR CONTROL BOX

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the rear control box.

BONNET ASSEMBLY

PARTS - TUMBLER ASSEMBLY

List of parts for the tumbler assembly related to the bonnet.

Related product manuals

IPSO IPD30STG User Manual

Table of Contents

Questions and Answers:

IPSO IPD30STG Specifications

Summary

IMPORTANT NOTICES—PLEASE READ

FOR YOUR SAFETY

IPSO DRYER WARRANTY

IDENTIFICATIONNAMEPLATE

SYMBOLS

Unpacking and General Installation

Outline Dimensions

General Specifications

General Information

DRYER COOL-DOWN

Main Drive Motors

Grounding Instructions

ELECTRICAL CONNECTIONS

ELECTRICAL CONTROLS SERVICING

Gas Piping Installation

Gas Pressure

Gas Supply

Gas Piping Installation (Illustration)

Pressure Testing Precautions

Gas Service Installation Instructions

GAS PRESSURE REGULATOR FOR LIQUIFIED PETROLEUM GASES

Multiple Vented Installation

Single dryer

Multiple dryers

Testing

Multiple vents

Dryer Installation With Separate Exhaust (Preferred)

Exhaust and Venting

DRYER AIR FLOW INSTALLATION

EXHAUST DUCT

MAKE-UP AIR

OTHER RECOMMENDATIONS

TROUBLESHOOTING

Rules for Safe Operation of Dryer

Service Safety Precautions

Flammable Liquid Precautions

ENERGY-SAVING TIPS

Operating Instructions—Coin Meter Models

ELECTRO-MECHANICAL COIN METER

COMPUTERIZED COIN METER

Temperature and Fabric Selection

Starting the Dryer Cycle

Post-Start Operation

Service Savers

DRYER WON'T START

DRYER WON'T HEAT

CLOTHES ARE NOT SATISFACTORILY DRY

GAS DRYER IGNITION

Service Call Information

TROUBLESHOOTING

Troubleshooting Chart

Motor Will Not Start

Motor Tripping on Thermal

Dryer Does Not Stop at End of Time Period

Motor Runs But Basket Will Not Revolve

Troubleshooting Chart

Dryer Noisy or Vibrating

Dryer Runs, But No Heat

Troubleshooting Chart

Dryer Runs, But No Heat (Continued)

Main Burners Burning Improperly

Main Burner Cycles On and Off

Low or High Gas Flame

Troubleshooting Chart

Dryer Too Hot

DIRECT SPARK IGNITION OPERATION

Dual Ignition System Note

DIRECTSPARK IGNITION OPERATION FLOW CHART

FRONT PANEL ASSEMBLY

DOOR ASSEMBLY

CONTROL PANEL

PARTS - TUMBLER ASSEMBLY

LINT DRAWER ASS'Y

PARTS - TUMBLER ASSEMBLY

THERMOSTAT ASS'Y