ISLA Instruments S2400 - Pattern Mode Keys; F2: Add pattern to song; F4: Toggle Live Looping; F5: Play only one bar

ISLA Instruments S2400 User Manual
– 22 –
Pattern Mode Keys
F2: Add pattern to song
F4: Toggle Live Looping on/off. The F4 key will be illuminated when Live Looping is active.
F5: Play only one measure. Press F5 while during playback to make the current measure repeat.
The F5 key will be illuminated when this feature is active. Press F5 again to deactivate.
F6: Rename the current pattern
F8: Lock/Unlock the faders for the current fader mode (see discussion of fader lock)
F9: Lock/Unlock the faders for all fader modes
A: During playback, toggles Parameter Playback Override on or off for the current fader mode.
During recording it toggles Live Parameter Record Overwrite for the current fader mode.
B: In Mix, Level, or Pitch fader mode: Toggles override/overwrite for the filter.
In Envelope mode: Envelope editor. In Loop/Slice mode: Waveform editor.
Shift+A: Displays the parameter settings for the current fader mode.
Shift+B: In Mix, Level, or Pitch fader mode: Filter settings.
In Envelope mode: Switch envelope. In Loop/Slice mode: Toggle looping.
A+Pad: Shortcut to Modify Pattern.
B+Pad: In Mix, Level, or Pitch fader mode: Shortcut to Modify Pattern for the filter.
Bank: Goes to the next bank.
Shift+Bank: Goes to the previous bank.
Bank+Number Key: Goes directly to a bank (Bank+1 for A, Bank+2 for B, etc.).
Bank+Mute/Solo/A/B: Toggles mute, solo, override or overwrite for all tracks in the current
bank at the same time.
Shift+Back: Stops all sounds in any mode.
If the current bank is a MIDI bank, Shift+Back does a “MIDI panic” and sends an all notes off CC
message, and a note off message for every note, on all of the ports and channels that have MIDI
tracks.
Back+Pad: Resets all sound parameters (level, pitch, filters, etc.) to their defaults for that track.
In Multi Mode, Back+Pad resets that track’s multi parameters for the current fader mode
(pitches, slices, etc.).
Erase+Pad: Quick erase the track from the current pattern, or selectively live-erase events.
Copy+Pad: Select a pad to copy. Continue holding copy, then press the destination pad. In Multi
Mode, the same action copies parameters from one multi pad to another.
Copy+Back: Undo/Redo
Copy+Enter: Set manual undo point
Copy+0 (zero): Cancel manual undo point