ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
3-4.1. Disassembly.
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
I.
If the engine has been operating and coolant is hot, allow engine to cool
before you slowly loosen filler cap and relieve pressure from cooling
system. Failure to observe this warning could result in severe personal
injury.
Use care when rotating engine on engine maintenance stand. If neces-
sary, use a lifting device to avoid severe personal injury.
Drain all coolant and engine oil, refer to end item maintenance manual. Check engine oil for metal contami-
nates.
Remove fan belt and alternator, refer to paragraph 3-24.1
Remove starter assembly, refer to paragraph 3-23.1.
Remove glow plugs, refer to paragraph 3-22.1.
Remove thermostat housing with thermostat, refer to paragraph 3-6.1.
Remove water pump, refer to paragraph 3-7.1.
Remove oil fitter and oil piping, refer to paragraphs 3-15.1 and 3-16.1.
Remove fuel filter, refer to paragraph 3-9.1.
Remove fuel injectors and piping, refer to paragraph 3-10.1.
Remove fuel injection pump, refer to paragraph 3-11.1.
Remove PCV assembly, refer to paragraph 3-20.1.
Remove intake and exhaust manifolds, refer to paragraph 3-21.1.
3-13
To Next Page
Loading...
