ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
m.
Remove rocker arm cover and rocker arm assembly, refer to paragraph 3-26.1.
n.
Remove pushrods, cylinder head assembly and cylinder head gasket, refer to paragraph 3-27.1. Check for
bent push rods and discard cylinder head gasket.
o.
Remove crank shaft pulley and front gear cover, refer to paragraph 3-25.1.
p.
Remove oil pan, refer to paragraph 3-17.1.
q.
Remove flywheel and flywheel housing, refer to paragraph 3-31.1
r.
Remove crankcase, refer to paragraph 3-29.1.
s.
Remove oil pump, refer to paragraph 3-18.1.
t.
Remove idler gear assembly, refer to paragraph 3-30.1.
u.
Remove pistons, connecting rods, and crankshaft, refer to paragraph 3-28.1.
v. Remove camshaft assembly, refer to paragraph 3-30.1.
w.
Disassemble cylinder block assembly, refer to paragraph 3-32.1.
x. Cap/cover all openings to prevent entry of foreign material.
3-4.2. Assembly.
a.
Remove all caps/covers installed during disassembly.
b.
Assemble cylinder block assembly, refer to paragraph 3-32.3.
c.
Install camshaft assembly, refer to paragraph 3-30.5.
d.
Install crankshaft, pistons, and connecting rods, refer to paragraph 3-28.5.
e.
Install idler gear assembly, refer to paragraph 3-30.5.
f.
Install oil pump, refer to paragraph 3-18.3.
g.
Install crankcase, refer to paragraph 3-29.3.
h.
Install flywheel housing and flywheel, refer to paragraph 3-31.3.
3-14
To Next Page
Loading...
