ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
l.
Refer to end item maintenance manual and remove governor mechanism from governor housing (17, FIG-
URE 3-7).
m.
Remove plug (12) and preformed packing (13) from top of governor housing (17).
n.
Remove bolt (14) with retainer (15) and six screws (16) securing housing (17) to end of pump. By tapping
housing (17) lightly with a mallet, separate it from the pump. Remove and discard gasket (18).
o.
Remove adapter (19) from pump housing (3).
p.
Lay pump on its side and remove four plugs (15, FIGURE 3-8) from bottom of pump, refer to FIGURE 3-11.
FIGURE 3-11. Removing Screw Plug (Typical)
q.
Secure pump in upright position.
r.
Remove coupling from camshaft using spanner wrench and socket wrench, refer to FIGURE 3-12.
FIGURE 3-12. Removing Coupling (Typical)
3-37
To Next Page
Loading...
