ARMY TM 9-2815-254-24
AIR FORCE TO 38G1-94-2
NOTE
Refer to FIGURE D-1, Appendix D to manufacture tappet holders.
n.
Hold tappet (23, FIGURE 3-8) with clamp (157931-6120). Align tappet guide with pump housing guide groove
and insert tappet (23) and spacer ring (26) through camshaft opening, refer to FIGURE 3-30.
FIGURE 3-30. Inserting Tappet
o.
Using tappet installer (157921-0120) through bottom plug hole, push tappet (23, FIGURE 3-8) upwards, align-
ing plunger flange with groove of cylinder sleeve (29).
p.
When, by pushing upward on tappet (23), plunger (24) is completely inserted into plunger barrel (37) and cylin-
der sleeve (29); insert tappet holder (FIGURE D-1, Appendix D) into small hole on tappet (23) body.
q.
If removed, install rings (22), shims (21), and bearings (20) on each end of camshaft (18).
NOTE
Code number (camshaft assembly mark) will be located on one end of
camshaft indicating governor end.
3-52
To Next Page
Loading...
