EasyManua.ls Logo

Italtherm CITY BASIC - Ambient Anti-Frost Function and Installation; Installation; Law and Regulation Prescriptions for Installers

Italtherm CITY BASIC
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
ATTENTION: the an-frost protecons cannot intervene in the absence of electricity. If you an-
cipate this possibility, we recommend you add a good brand of an-freeze to the heang sys-
tem, following the producers instrucons.


When the power comes back on, the boiler will check the temperature measured by the two
probes and, if it suspects freezing veried by a parcular automac control cycle, alarm 39 will
be triggered. For more details, see the relave descripon in the paragraph "Alarms - boiler
block" on page 30.
We recommend that you completely empty the hot and cold sanitary water system, including
the sanitary circuit and the boilers sanitary exchanger. The an-frost funcon does not protect
the sanitary circuit outside the boiler.
Ambient An-Frost” Funcon
Note: if you want to use the Ambient An-Frostfuncon that is oen available in common room
thermostats or chronothermostats, it is necessary to leave the boiler in Winter
mode and NOT
in stand-by.
The Ambient An-Frostfuncon does not protect the sanitary circuit outside the boiler and,
especially, in areas where the heang system doesn’t reach. For this reason, we recommend
that you empty the cold and hot sanitary water from the parts of the system that are at risk of
freezing.


Note for the translator/writer: Place in this paragraph all the recommendaons relevant to the compli-
ance with laws in the desnaon naon/country (if any). As an example (from Italian regulaon):
as this boiler has an heat output lower than 35 kW (about 30000 Kcal/h),
it is not required to install the appliance in a dedicated room, provided that the room complies with
the regulaon in force and that all installaon rules assuring a safe and regular gas boiler operaon,
are strictly respected.
 when
a boiler with air draught from the installaon room (B… appliance type) is installed. Venlaon
must be made and sized in compliance with Laws and Rules in force.
at the end of the installaon, the installer must:
explain the operaon of the boiler and its safety devices to the user;
give this user this booklet and the documentaon within his/her competence, duly lled in where
required.

Table of Contents

Related product manuals