EasyManua.ls Logo

Italtherm CITY BASIC - Boiler Controls and External Devices

Italtherm CITY BASIC
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
8
Posion on which the knob 12 should be posioned to turn the boiler o or to reset
a boiler block.
9
Posion on which the knob 12 should be posioned to acvate the boiler in Winter
mode (both Heang and Domesc Hot Water funcons available).
10
Scale on which the knob 12 should be posioned to adjust the Heang system tem-
perature.
11
Posion on which the knob 12 should be posioned to acvate the boiler in Summer
mode (only Domesc Hot Water funcon available and exclusion of Heang)
12
boiler
mode
Knob that allows to switch the boiler in OFF mode
 Summer 11 or Win-
ter
9 and to adjust the Heang system temperature 10.
If the Remote Control Kit is installed, see "Remote Control Kit" on page 39.
13
DHW
Knob that allows to adjust the Domesc Hot Water temperature (along the scale
14 ).
The use of the posions 
14
Scale on which the knob 13 should be posioned to adjust the Domesc Hot Water
temperature.
15
service
Posions of the knob 13 which use is reserved to the technician.
Do not turn the knob 13 on these posions.
16
Commands on the lower side
17
System pressure gauge
18
System lling and pressure restoring cock
19
GAS cock
Commands outside the boiler
Externally the boiler, suitably posioned in the building
(generally by the installer or by the electrician), two devices
that the user should access to, are present. The presence
and the characteriscs of these devices are prescribed by
the regulaon in force.
Two-pole switch: it is located usually close to the boiler and it's for electrically insulang the boiler itself
from the domesc mains power supply network.
Room thermostat: it commands electrically the boiler to acvate or deacvate the heang system, in
order to keep the room temperature (detected by a sensor) within a value set by the user, Regulaon
in force prescribe its posioning, the temperature limits within the user can adjust it and the periods
of heang. On trade are available programmable room thermostats: most of them allow to make a
weekly programming of various temperature levels, besides special programs for various purposes.
We suggest to choose original ITALTHERM accessories
00001_00
17
18
19

Table of Contents

Related product manuals