EasyManua.ls Logo

Italtherm CITY BASIC - Remote Control Kit

Italtherm CITY BASIC
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
39

This remote control is more than a simple room thermostat.
Thanks to this, it is possible to manage the boiler in all its set-
 like DHW and CH temperature adjustment, boiler reset in
case of boiler block, and of course it works as a room thermo-
stat both in manual and weekly program mode. Its powered by
the boiler (in safety low voltage), so .
Extract the Remote Control from its package. 
   

Nor the Remote Control neither the relevant cable coming
from the boiler must not, for any reason, be connected to

To avoid malfuncons due to electrical noise, the Remote
Control connecons, as well as all low-voltage connecons,
should be kept separated from power supply cables, e.g. by
enclosing it into separate raceways.
The maximum overall cable length shouldn't exceed 50 m.
 Cut o electricity from boiler;
 install the device as described in the paragraph 4 of the supplied instrucon booklet;
 link the Remote Control wirings to the "Room Thermostat - Remote Control" cable coming out of
the boiler, by means of a suitable bipolar terminal. See also "Electrical diagram" on page 37;
Note: The Remote Control link is not polarized.
 power supply the boiler; 
on Summer otherwise the
 and the boiler goes into alarm 31 described below;
 check the correct work of the device. The electronics should recognize it automacally.
  ; the boiler work is man-
aged by the Remote Control, including the OFF, Summer and Winter modes, and the technical

Signal Probable causes 
31
Communication
error between the
Remote Control (if
present) and the
boiler
Disconnect the electrical supply to the boiler for 30 seconds by op-
erang the suitable external bipolar switch, turn the boiler's Sum-
mer/Winter knob on Summer
, then power supply the boiler.
If the lockout persists or reappears, call the Service Centre. Under
these condions, the boiler works only in DHW.
For the Technician: Problems on the oponal Remote Control
connecon link (passing close to supply cables or other electromag-
nec eld sources; connecon failure; cable length over 50 meters).
CONTROLLO REMOTO
EASYREMOTE
MANUALE DI
ISTRUZIONI

Table of Contents

Related product manuals