EasyManua.ls Logo

Italtherm CITY BASIC - Servicing Warnings and Procedures

Italtherm CITY BASIC
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
Signal Probable causes 
42
RED
YELLOW
System error
Anomaly of inner
boiler device(s)
Mains electrical
power supply out
of tolerance limits
Detect the fault or anomaly also referring to the technical literature
reserved to the service centres.
– –
(??)
The “Hot Water
knob
is on a
posion reserved
to the techni-
cian:
or service .
Turn the knob back along the scale .
– –
(??)
RED

it has been started,
by mistake (moreo-
ver very improb-
able), a procedure
reserved to the
Technician
In order to avoid malfuncons, do the following as soon as possible:
f turn the knob
on the o/unlock  posion;
f turn the "Hot Water" knob
along the scale ;
f turn the knob
on the normal working posion (Summer or
Winter
along the scale ).
Warnings for servicing
All servicing operaons and gas conversions MUST BE CARRIED OUT BY QUALIFIED TECHNI-
CIANS, in compliance with the norms and laws in force (see an indicave list on page 4). Moreo-
ver, MAINTENANCE operaons must be carried out in compliance with the manufacturer pre-
scripons and with the laws and rules presently in force, for the parts not menoned in this
handbook.

 Normally, it will be necessary to
execute the following operaons:
f Remove any possible oxidizaon from burners and electrodes;
f Remove the scale from the exchangers;
f Check integrity and stability of the ceramic bre coverings in the combuson chamber and proceed
eventually to substuon;
f Check the boiler ignion, switching o and operaon;
f Check the water and gas connecons ghtness;
f Check the gas consumpon at the minimum and maximum output;
f Verify that safety devices are correctly working;
f Verify the correct funconing of control and adjusng devices;
f Verify the correct funconing and the integrity of the ue system and of the relevant terminals and
accessories
f In case of works or servicing of the structures placed near the above menoned ducts and /or de-
vices and their accessories, switch o the boiler;
f Do not leave any inammable tanks and/or substances in the installaon room;

Table of Contents

Related product manuals