Functions and Features
The detailed operation steps are as follows.
1. Press [Shift]+[I-set] (Function) to enter function menu interface.
2. Use left and right keys or rotate the knob to select List and press [Enter]
key to confirm.
3. Use left and right keys or rotate the knob to select Edit List and press
[Enter] key to confirm.
4. Use knob to set the list name and press [Enter] key to confirm.
5. Use left and right keys or rotate the knob to select List Setup and press
[Enter] key to confirm.
a. Select Mode to set list mode: CC/ CV.
b. Select End State to set running state after the list program is running
over.
• Normal: keep outputting the voltage and current setting in main inter-
face when the dwell time is over.
• Last: keep outputting the last step when the dwell time is over.
c. Select Repeat to set the number of list repetitions.
6. Select Edit Step and press [Enter] key to confirm.
7. Use knob to set the desired list step number and press [Enter] key to
confirm.
To the left of the slash is the desired step number to be edited and to the
right of the slash is the total steps number of the list program. The total num-
ber of steps changes by the addition of the number of steps in the editing
process.
a. Select Current or Voltage to set the current or voltage value.
b. Select Slope to set the slope of the step.
c. Select Time to set the dwell time of the step.
d. Select Next to set whether to edit the next step. If set to Yes, repeat
steps a through c to set the parameters for next step. If set to No, the list
step parameters setting is over.
8. If you need to continue to adjust the list step, you can use the following set-
tings to insert, add or delete steps.
• If you need to insert steps, select Insert Step and press [Enter] key to
confirm. Use knob to set the insert location and press [Enter] key. Re-
peat steps 7a through 7d to set the parameters for the inserted step. The
inserted step is before each specified step and you can insert multiple
steps continuously.
• If you need to add steps, select Add Step and press [Enter] key to con-
firm. Use knob to set the add location and press [Enter] key. Repeat
steps 7a through 7d to set the parameters for the added step. The added
step is after each specified step and you can add multiple steps
continuously.
• If you need to delete steps, select Delete Step and press [Enter] key to
confirm. Use knob to set the delete location and press [Enter] key.
Copyright © Itech Electronic Co., Ltd.
72
To Next Page
Loading...
Need help?
General
