Functions and Features
• If you need to delete all steps, select Delete all and press [Enter] key to
confirm. Use knob to select Yes and press [Enter] key.
4.7.2 Copy List Program
For an existed list program, you can copy and name it a new list program. Then
you can edit the new list program, insert steps or delete steps. This function sim-
plifies the edit operation for similar list program. The operation steps are as
follows.
1. Press [Shift]+[I-set] (Function) to enter function menu interface.
2. Use left and right keys or rotate the knob to select List and press [Enter]
key to confirm.
3. Use left and right keys or rotate the knob to select Edit List and press
[Enter] key to confirm.
4. Use knob to set the list program name and press [Enter] key to confirm.
5. Select Copy File X to X and press [Enter] key to confirm.
6. Use knob to select setting source List program name and target List program
name and press [Enter] key to confirm.
4.7.3 View List Program
Before selecting and running the list program, you can view the related parame-
ters and each step of the existed list program. The operation steps to view the
list program are as follows.
1. Press [Shift]+[I-set] (Function) to enter function menu interface.
2. Use left and right keys or rotate the knob to select List and press [Enter]
key to confirm.
3. Use left and right keys or rotate the knob to select Recall List and press
[Enter] key to confirm.
4. Use knob to select the list program to view and press [Enter] key to confirm.
5. Select List Setup and press [Enter] key to enter the view page of list file.
Use left and right keys or rotate the knob to view the following parameters.
• Mode: the operation mode for list program.
• End State: the running state after the list program is running over.
• Repeat: the number of list repetitions.
6. Select View Step and press [Enter] key to confirm.
7. Use knob to select the list step to view and press [Enter] key to confirm.
To the left of the slash is the desired step number to view and to the right of
the slash is the total steps number of the list program. At this point, the inter-
face displays all steps and automatically locates at the selected step.
8. Use knob or left and right keys to view all steps.
Copyright © Itech Electronic Co., Ltd.
73
To Next Page
Loading...
Need help?
General
