Inspection and Installation
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to
enter the system menu.
2. Rotate the knob to select I/O and press [Enter].
3. Press the Left/Right key to select LAN and press [Enter].
4. Press the Left/Right key to select IP-Conf and press [Enter].
5. Press the Left/Right key to select Manual and press [Enter].
6. Set the IP, Mask and the other parameters in turns, and press [Enter].
After the last parameter Socket Port is set, the system will return to the
LAN setting interface shown as below:
SYSTEM I/O CONF LAN
Info IP-Conf Serv-Conf Reset
7. Press the Left/Right key to select Reset to confirm the settings of IP-
Conf.
• Serv-Conf
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to
enter the system menu.
2. Rotate the knob to select I/O and press [Enter].
3. Press the Left/Right key to select LAN and press [Enter].
4. Press the Left/Right key to select Serv-Conf and press [Enter].
5. Rotate the knob to select the service you want to enable and press
[Enter].
6. Rotate the knob to select whether to enable the service and press
[Enter].
– On: Indicates that the service is enabled.
– Off: Indicates that the service is disabled.
2.5.2.1 Using Web Server
The instrument has a built-in Web server for monitoring and controlling the in-
strument via a Web browser in PC. To use the Web server, connect the instru-
ment and PC over LAN interface and enter the instrument's IP address into the
address bar at the top of your PC's Web browser, you can access the front pan-
el control functions including the LAN configuration parameters.
Copyright © Itech Electronic Co., Ltd.
34
To Next Page
Loading...
