To Next Page

To Previous Page

Power Supply Function

6. Rotate the knob to select the List file.

7. Press the Left/Right key to select Load, press [Enter] to complete the im-

port, and wait for the trigger to run this List file.

At this point, the interface returns to the main interface of the system and

LIST RUN is displayed in the lower right corner.

Select Internal List Program

You can select a List file saved inside the instrument to be in the Open state

and wait for subsequent triggers to run. The procedures are as follows:

1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to en-

ter the function menu.

2. Select 1. LIST: Off and press [Enter].

3. Press the Left/Right key to select Open and press [Enter].

4. Press the Left/Right key to select Internal and press [Enter].

5. Set the name of the List file to be recalled (that is, the file name set in Edit),

and press [Enter].

The interface returns to the main interface of the LIST function, which is dis-

played as follows:

FUNCTION LIST

Run Edit Open Export

If you select Run and press [Enter], the instrument will enter LIST mode

and wait for the trigger to run.

Export List Program

Supports exporting the internal List file to an external USB flash drive. The ex-

ported List file is saved in .csv format.

1. Insert the USB flash drive into the front panel USB connector.

2. Press the composite keys [Shift]+[I-set] (Function) on the front panel to en-

ter the function menu.

3. Select 1. LIST: Off and press [Enter].

4. Press the Left/Right key to select Open and press [Enter].

5. Press the Left/Right key to select Internal and press [Enter].

6. Set the name of the List file to be recalled (that is, the file name set in Edit),

and press [Enter].

ITech IT-M3900C Series User Manual

Questions and Answers: