Inspection and Installation
DNS is an internet service that translates domain names into IP addresses.
It is also needed for the instrument to find and display its hostname assigned
by the network. Normally, DHCP discovers the DNS address information;
you only need to change this if DHCP is unused or not functional.
• DNS2: This field enters the secondary address of the server. Contact your
LAN administrator for server details. The same numbering notation applies
as for the IP Address. A value of 0.0.0.0 indicates that no default server is
defined.
• Socket Port: This value indicates the port number corresponding to the
service.
Serv-Conf
Configurable services include: MDNS, PING, Telnet-scpi, Web, VXI-11, and
Raw Socket.
How to Configure
• IP-Conf
Take manual configuration as an example. The steps are as follows:
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to
enter the system menu.
2. Rotate the knob or press the Up/Down key to select I/O and press
[Enter].
3. Press the Left/Right key to select LAN and press [Enter].
4. Press the Left/Right key to select IP-Conf and press [Enter].
5. Press the Left/Right key to select Manual and press [Enter].
6. Set the IP, Mask and the other parameters in turns, and press [Enter].
After the last parameter Socket Port is set, the system will return to the
LAN setting interface shown as below:
SYSTEM I/O CONF LAN
Info IP-Conf Serv-Conf Reset
7. Press the Left/Right key to select Reset to confirm the settings of IP-
Conf.
• Serv-Conf
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to
enter the system menu.
2. Rotate the knob or press the Up/Down key to select I/O and press
[Enter].
Copyright © Itech Electronic Co., Ltd.
38
To Next Page
Loading...
Need help?
General
