To Next Page

To Previous Page

Power Supply Function

1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to en-

ter the function menu.

2. Select 1. LIST: Off and press [Enter].

3. Press the Left/Right key to select Open and press [Enter].

4. Press the Left/Right key to select Internal and press [Enter].

5. Set the name of the List file to be recalled (that is, the file name set in Edit),

and press [Enter].

The interface returns to the main interface of the LIST function, which is dis-

played as follows:

FUNCTION LIST

Run Edit Open Export

6. Press the Left/Right key to select Run and press [Enter].

At this point, the interface returns to the main interface of the system and

LIST RUN is displayed in the lower right corner.

7. Turn on the [On/Off].

8. Based on the selected trigger method, perform the trigger operation.

Take the manual trigger as an example. Press [Shift]+[On/Off](Trigger) on

the front panel to run the selected List file. For details about the List trigger

method, see 5.8 Select Trigger Source (Trig Source).

• The system will adjust the working mode of the power supply according to

the CC or CV priority mode set in the List file. For example, if the current

power supply is in the CV priority mode, and the list file to be run is set to the

CC priority mode, then the power supply will work in the CC priority mode

after the List file is triggered to run.

• After the List file finishes running, the system determines whether to return

to the working mode before the List is run according to the Normal or Last

option you selected.

Stop Running the List Program

When the List program is running, if you need to stop running, you can do the

following: Press the composite keys [Shift]+[I-set] (Function) on the front panel

to enter the function menu.

At this point, the interface will prompt whether to stop the running of the Func-

tion, you can press the Left/Right key to select Stop, then the running will be

stopped, and the Function menu item will be displayed, you can re-enter the

Function menu for editing; if Reset is selected, it means to stop the present run-

ning and return to the main interface to wait for the next trigger operation; if

Pause is selected, it means that the present running is suspended, and you can

continue to run by selecting Resume.

ITech IT6000D Series User Manual

Questions and Answers: