Power Supply Function
Internal Open the List file stored inside the instrument.
Recall Inner
File
Set the name of the recalled List
file.
Export Export the internal List file of the instrument to an external
USB flash drive.
File
Name
The name of the exported list file. The default suf-
fix is .csv, and the file name can only be a string
of numbers.
Edit Edit list program.
CC / CV Set the operation mode for list program: CC prior-
ity or CV priority.
Step
Count
The total number of steps included in the List
program.
Step 1
Value
Current value or voltage value setting for Step1.
(The voltage appears when CV priority is se-
lected; the current appears when CC priority is
selected.)
Step 1
Slope
Slope value setting for Step1.
Step 1
Width
Dwell time setting for Step1.
Repeat Set the number of list file repetitions.
End
State
Set the running state after the list program is run-
ning over.
Last After the List program finishes run-
ning, the output is kept as the set-
ting in the last step, and the
working mode remains as the set-
ting in the List file.
Normal After the List program finishes run-
ning, the working mode and volt-
age/current output return to the
settings before the List running.
Trig Out Function switch that triggers the signal output. It
is applicable to the scenario of synchronously
controlling multiple units, that is, by connecting
Copyright © Itech Electronic Co., Ltd.
58
To Next Page
Loading...
Need help?
General
