Panel function introduction
Copyright © Itech Electronic Co., Ltd. 23
Switch channel via key：IT 8700 is a muti-load, one
main frame controls all modules. Every module has its own
channel number, select the channel to be edited on the main
frame panel first, then start to edit, e.g. if you want to edit the
5th channel, press key first, the VFD will show all the
installed channels, press number key 5 directly to switch to 5
channel, now the channel can be edited .
key is used to save data：After selecting the channel,
edit its parameters, set work mode, voltage, current, Slope,
the dynamic parameters and so on. Press key to
save, up to 101 groups of parameters can be saved. All the
parameters are saved in the Non-volatile memory, support
power-off saving.
key is used to recall data: key can be used to
fast recall the saved 101goups parameters. All the used
parameters only need to be edited and saved for one time and
they will be always saved in the EPROM. You just need to
recall them if necessary. It brings great convenience to the
users, and save time.
key is used to enter the specific channel’s menu：press
this key, you can achieve A/B transient mode, CC/CV/CR
mode and so on, this menu has been introduced in detail in
the menu list.
key is used to control module’s input state on/off:
when you enabled the synchronization function in the menu of
a channel, the key can correspondly control the on/off state of
the channel.
key is used to trigger: when you edit the auto test file
or the transient output, you should select the triggering
source, this load have 5 kinds triggering mode, panel
triggering is only one of them. It will be introduced in detail in
the front panel triggering operation chapter.
key is used to start automatic test：after recalling the
edited automatic test file, press up and down to select ,
press key to start automatic test.
key is used to pause：only press key to pause
when running a automatic test, at this time the VFD will
display pausing at a step, press key once again to test
the file continuously.
4. Comprehensive key+ ～ number keys： ～ are number input
keys； + / / key will respectively enter 3 menu, it has been
introduced in detail in the menu list; if the load is in remote sense mode,
press + key can switch to local mode; + key can lock
module’s panel keyboard and knob, repress them can unlock it; exit
key, can be used to exit any working state; key means a point;
key is used to move up, select the menu; key is used to
move down, select the menu; key is used to confirm; key is
a comprehensive key.
To Next Page
Loading...
