Operations introduction
Copyright © Itech Electronic Co., Ltd. 42
>High Range
Low Range
5. Press key to enter the current setting <Iset>, such as set the current
to be 1.25A，press key to confirm. If any error, press Esc to back.
CH01
Const Current
Set= 1.25A
Enter Esc
6. Press key to enter the maximum voltage value setting, press .
Press numeric key to set the maximum voltage value.
CH01
Voltage Upper
Limit=82.000V
Enter Esc
7. Press key to enter the minimum voltage value setting, press .
Press numeric key to set the minimum voltage value.
CH01
Voltage Lower
Limit=0.000V
Enter Esc
8. Press key to enter the rise slope setting, such as set the rise slope
to be 1A/uS. Press key to confirm
CH01
Rise Speed Set
= 1.00A/uS
Enter Esc
9. Press key to enter the fall slope setting, such as set the fall slope
to be 2A/uS. Press key to confirm
CH01
Fall Speed Set
= 2.00A/uS
Enter Esc
10. Press key to exit
11. Press to open the load’s input
CH1 CC ON
Vdc=0.0000V
Adc=0.0000A
Wdc=0.00W
4.4 Transient operation
Transient operation enables the module to periodically switch between two load
levels, as might be required for testing power supplies. Transient operation can
be turned on and off at the front panel ( and keys), before you turn
on the operation, you should set the parameters associated with transient
operation ( ). The parameters include: A level, A width, B level, B width,
and transient testing modes.
The transient testing modes have 3 kinds: continuous, pulsed, or toggled.
⚫ Continuous: Generates a respective pulse stream the toggles between two
load levels
⚫ Pulse: Generates a load change that returns to its original state after some
To Next Page
Loading...
