Installing the 100W-R and 100WP-R ERT Modules
TDC-0951-005 100W-R and 100WP-R Datalogging ERT Module Installation Guide 35
Proprietary and Confidential
2. Installation requires a 100W-R ERT module for an InVISION or Scancoder register. Installation for a
Digital register requires a 100WP-R.
3. Strip 1/2-inch of insulation from the end of the brown, gray, and yellow wires.
4. Place the ERT module on the mounting bracket and route the yellow, gray, and brown wires through the
opening.
Note A gasket is not required.
To Next Page
Loading...
