Attaching the Direct Mount Standard (5 dBi) 915 MHz Antenna
1. Slide the black rubber boot onto the base of the antenna as shown in the following
illustration.
2. Screw the antenna onto the top of the collector or repeater. Be careful not to cross-
thread the connectors. Do not over-tighten.
3. Push the rubber boot as close as possible to the top of the collector or repeater as
shown in the following illustration.
TDC-0971-011 CCU 100 and Repeater 100 Installation Guide 21
Proprietary and Confidential
To Next Page
Loading...