Attaching the Collector or Repeater
An integrated mounting support on the back of the collector or repeater enclosure slides
into the slot in the center of the mounting bracket. A set screw locks the collector or
repeater to the mounting bracket. Orientation of the enclosure may be adjusted +/- 16
degrees horizontal to compensate for different angles.
Pipe Mount
The following image illustrates a typical vertical pipe installation. The collector or
repeater may also be attached to a horizontal pipe.
TDC-0971-011 CCU 100 and Repeater 100 Installation Guide 23
Proprietary and Confidential
To Next Page
Loading...