Attaching the Collector or Repeater
Wall Mount
The following image illustrates a wall mount installation. In this scenario, two brackets
are secured to the collector or repeater and the entire assembly is attached to the wall. It
may be necessary to use the remote 900 MHz antenna kit to achieve optimum RF
performance and GPS coverage if the collector or repeater is mounted indoors, or if the
wall obstructs the desired RF path.
To mount the collector or repeater on a wall
1. Remove the integrated mounting support (bolt, washer, lock washer, and mounting
disk) from the back of the device. These parts are not used for this mounting
configuration.
2. Using four bolts, secure the collector or repeater to the two wall mounting brackets
with the antenna in the upright position.
3. Using four appropriate screws or bolts (not provided by Itron), attach the mounting
brackets to the wall.
TDC-0971-011 CCU 100 and Repeater 100 Installation Guide 27
Proprietary and Confidential
To Next Page
Loading...