Chapter 3 Installing the Collector or Repeater
2. Attach the 4G WAN antenna on the N-Connector on the bottom of the CCU labeled
WAN.
Installing the Battery
If you are installing a battery with a ferrite bead on the wires, as shown in the following
illustration, follow the directions in To install a battery (ferrite bead) on page 36.
If the battery does not have a ferrite bead on the wires, see To install a battery on page 34.
To install the battery
1. Remove the battery cover by loosening the four screws securing it.
These are captive screws. It is not necessary to fully remove the screws from the
battery cover.
34 TDC-0971-011 CCU 100 and Repeater 100 Installation Guide
Proprietary and Confidential
To Next Page
Loading...