Appendix A Detailed Collector or Repeater Specifications
Antenna Specifications
Specifications for the 900 MHz, GPS, and WAN antennas are listed in the following
tables.
Important All coaxial cable connections must be properly weather-proofed per
industry standards unless otherwise specified. This includes any connections for the
antennas and the collector or repeater components. If the collector or repeater is
installed indoors, only the connections located outside need to be weather-proofed.
This device has been designed to operate with the antennas listed below. Antennas not
included in this list are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
900 MHz antennas
Specification Standard 5 dBi
High gain (8.15 dBi)
Gain 3 dBd (5.15 dBi) 6.0 dBd (8.15 dBi)
Horizontal beam width Omni directional Omni directional
Vertical beam width -3dB minimum, +/- 16 degrees from
horizontal
17 degrees
Electrical down tilt available 0 degrees 0 degrees
Power rating 50W 100W
Impedance 50 ohms 50 ohms
Termination Type N male Type N female
Lightning protection Direct ground Direct ground
Overall length 18 in. 65 in.
Radome diameter 1.00 in. OD 1.310 in. OD
Mounting area length n/a ~8 in.
Weight (without clamps) 1 lb. 3 lbs.
Maximum wind speed 160 mph 125 mph
Wind load @ rated wind
speed
n/a 57 lbs.
Gain 30 dB 0 dBd (806-896)
3dBd (1850-1990)
Horizontal beam width Omni directional Omni directional
Power rating N/A 100 W
Impedance 50 ohms 50 ohms 50 ohms 50 ohms
60 TDC-0971-011 CCU 100 and Repeater 100 Installation Guide
Proprietary and Confidential
To Next Page
Loading...