29
ENGLISH
Marine gear lubricant level inspection
Check oil level in the marine gear. Follow the instructions provided in
the manual provided by the marine gear manufacturer.
Coolant level inspection
Proceed only with engine not running and at low temperature to avoid
any risk of burns.
Remove the filling pan pressure cap (3 in the previous page)
Visually inspect oil level.
Refill if necessary using a 50% mixture with clear water (not
distilled) and Paraflù 11. (See REFUELLING table).
Exhaust pipe/s integrity inspection
Visually check that the discharge system of exhaust gases is not clogged
not damaged.
Make sure there is no dangerous fumes inside the hull. Contact the
Yard if necessary.
Water drain from fuel pre-filter
The high risk of refueling with fuel polluted with foreign bodies and
water requires inspections to be performed even if no alarm is
triggered on the on board panel.
Proceed with engine not running.
Place a basin under the pre-filter in order
to collect liquids.
Unscrew the cock plug (1) located in the
pre-filter lower section; in some fittings
the plug includes the diesel oil water
sensor.
Drain the liquid until it is detected as
“diesel oil” only.
Manually close the plug by screwing
completely.
Dispose drained liquids observing current
regulations in force.
Check the electrolyte solution level in batteries
Proceed by placing the batteries on an horizontal plane.
Visually inspect that the liquid level is included between "Min" and
"Max". If no reference marks is available, check that the liquid covers
the lead plates in the elements by approximately 5 mm (0.20 in).
If necessary refill only with distilled water those elements whose
level is lower than the minimum.
Contact a specialized shop in case the battery needs recharging.
WARNINGS
After refilling make sure oil level does not exceed "Max" on the stick.
Insert the dip stick all the way down and tighten the cap by turning
it clockwise until it comes to a full stop.
1
05_018_V
To Next Page
Loading...
Need help?
General
