Iveco Motors Cursor 13 Series User Manual

37
ENGLISH
Check tension and conditions of auxiliary parts belt
Proceed only with engine not running and at low temperature to
avoid any risk of burns.
 Remove pulley protection.
 Check belt for brakes, wear, oil or fuel presence. Replace if
necessary.
 Check tensioning as shown in the picture.
 Replace casing and tighten fastenings.
Coolant replacement
Proceed only with engine not running and at low temperature to avoid
any risk of burns.
 Use basins to avoid coolant dispersion in the environment.
 Remove plugs on the circuit and wait for it to bleed completely
(see ENGINE TECHNICAL DATA for location). Replace when
empty. Watch sealing integrity.
 Refill the circuit as described in REFILLING table.
 Degas and refill the circuit as instructed in section PRESCRIPTIONS
FOR FIRST START-UP.
Oil vapor filter replacement
Proceed only with engine not running and at low temperature to avoid
any risk of burns.
 Remove engine fittings to access filter housing.
 Loosen screws, remove filter housing cover (1).
 Remove and dispose the filter (2) observing current regulations in
force.
 Slide the new filter, observing the assembling direction. Reinforcing
items (3) should be visible.
 Place the cover back into its housing.
05_070_C

Iveco Motors Cursor 13 Series Specifications

General

Brand	Iveco Motors
Model	Cursor 13 Series
Category	Engine
Language	English