42
5. Operation and Configuration
Editing parameters
Parameters are entered or edited in two steps.
Example: Setting the holding temperature
1. Press the [T] button.
2. Enter the desired holding temperature and confirm by
pressing the green button.
2. Press the [Activate Write-Protection] button.
3. Press the [Back] button to leave the Options menu.
The holding temperature was successfully changed. All the other parameters shown in the firing curve can be changed /
edited in the same way.
Changing the program options
Pressing the [Options] button opens the menu for advanced program options.
Example 1: Activating the program write-protection
1. Press the [Options] button.
To Next Page
Loading...
