14
IVT 495 TWIN 9518799
Setting the room temperature
(This requires a room sensor, which is an
accessory.)
A room sensor can be installed to complement the
outdoor sensor. The sensor affects the heat curve
by increasing or reducing the flow temperature to
adapt to the selected room temperature. This is
especially suitable in houses where a hot-air stove
or another temporary heating source is used.
Room sensor control does not work in all houses,
dependent on the lay-out (not used with floor
heating).
1. Press the right button once and the text Set the
house heating here appears on the display.
2. Press the right button once again and the text
Heat more/less range 0-10 appears on the
display.
3. Turn the dial until Setting room temperature
appears on the display.
4. Press the right button, the display now shows
Set value:.
5. Press the right button (Adjust). Turn the dial
until the required value has been set.
6. Press the right button when the required value
has been set (Save). The value is now saved.
Press the left button to return to the main
menu.
Set the house
heating here 1
Heat more/less
range 0-10 1.1
Setting room
temperature 1.10
Set value: 20,0
Return Adjust
Cancel 20,0 Save
Room temperature
USER
To Next Page
Loading...
Need help?
General
