9
Before operating the machine, verify the following:
• Strainers are clean and in place.
• Drain stopper is installed.
• Wash/rinse arm is screwed securely into place and end-caps are tight.
• Wash/rinse arm rotates freely.
To energize the machine, turn on power at the service breaker. The voltage should
have been previously veried as correct. If not, the voltage must be veried before
energizing the unit.
Before the heater element can be energized, the heater tank must be initially lled
with water.
1. Press and hold FILL button until water overows into the wash strainer, then
release the button.
2. The heater tank is now lled with water.
3. Turn o the machine by pressing the ON/OFF button.
INSTRUCTIONS
OPERATION
PREPARATION
POWER UP
INITIAL
START-UP
CAUTION! Damage to
the heater element will
occur if the element is not
submerged in water.
!
CAUTION
To Next Page
Loading...
Need help?
General
