To Next PageTo Next PageWhy doesn't the wash or rinse heater work in my Jackson TempStar Dishwasher?
If the wash or rinse heater in your Jackson Dishwasher isn't working, check the heater element for continuity; if it's open, replace the heater. Another potential cause is a faulty heater contactor, which would also need replacement. Lastly, verify the operation and settings of the thermostats; replace them if necessary.
Why is my Jackson TempStar Dishwasher filling slowly, and the rinse is weak?
If your Jackson Dishwasher fills slowly or the rinse is weak, start by removing and cleaning the rinse arms, as they might be clogged or obstructed. Also, check the incoming water pressure and adjust the water pressure regulator to ensure it's at 20±5 PSI. Lastly, inspect the Y-strainer for clogs and clean it out if necessary.
What to do if my Jackson TempStar will not fill after the door is closed, but the power is on?
If the Jackson Dishwasher will not fill after the door is closed but the power light is on, the rinse solenoid valve may be faulty, requiring repair or replacement. Another potential cause is a faulty door switch; verify its wiring, and if correct, replace the switch. Lastly, a fouled or faulty high-level probe could be the issue; clean the probe, and if it's still not working after cleaning, replace it.
Why does my Jackson Dishwasher run continuously in the wash cycle?
If your Jackson Dishwasher runs continuously in the wash cycle, it might be in delime mode. Change the operation mode from DELIME to NORMAL. If that's not the issue, the wash cycle delay timer could be faulty. If the red light isn't on during cycles B, C, or D, replace the cycle timer. Also, ensure the delay potentiometer is correctly adjusted for cycles B, C, or D. A faulty cam timer could also be the cause; in this case, also adjust the delay potentiometer for cycles B, C, or D. Confirm that the wash cycle delay timer is functioning correctly, that the timer motor is receiving power, and that there are no obstructions limiting the rotation of the cam timer.
Why are the dishes not coming clean in my Jackson Dishwasher?
To address dishes not coming clean in your Jackson Dishwasher, first, ensure that the incoming water, rinse water, and wash water temperatures meet the minimum requirements specified on the machine's data plate. Next, adjust the detergent concentration to match the water volume in the machine. Finally, if you're using a solid dispenser, check and replace the canister if it's empty.
What to do if my Jackson TempStar Dishwasher doesn’t drain when turned off?
If your Jackson Dishwasher isn’t draining when you switch it off, here’s what to do: * Check for and remove any drain clogs. * Remove the standpipe and run the drain cycle again.
General| Model | TempStar Series |
|---|---|
| Voltage | 208-240V |
| Number of Wash Cycles | 1 |
| Color | Stainless Steel |
| Category | Dishwasher |
| Voltage Options | 208V, 240V |
| Capacity | 60-80 racks per hour |
| Water Consumption per Cycle | 0.5-1.0 gallons |
| Water Consumption per Rack | 0.84 gallons |
